tphan
Posts: 1
Joined: Sun Jul 07, 2019 11:59 pm

infill over fill?

Sun Jul 14, 2019 7:42 pm

I was printing a simple box with 4 wall. I notice that when printing the wall the nozzle was kind of bumming against the surface when print the infill. It look like too much infill was create for the wall causing it to have a higher z position. it pushing the nozzle away. I have infill at 20% but it look like the slicer was create too much infill.( see attachment)
Attachments
infill.PNG

Return to “Troubleshooting and Bug Reports”