MusicManAsman
Posts: 4
Joined: Thu Jul 12, 2018 10:43 pm

Start Point Defects...Please Help!!

Sun Jul 28, 2019 11:22 pm

Hi all!
So I have been trying to troubleshoot this issue for what seems like forever. From everything I've read so far this issue usually seems to have to do with my retraction settings, but I have tried every single different type of retraction setting that I can think of, and I've even turned retraction completely off to see if that would help at all, and it doesn't seem to really do anything to fix it. From what I can tell these defects are 100% linked to the starting points of each layer, but I cannot seem to make them any better no matter what I try. Any help or suggestions would be most appreciated!! Pictures for reference below. Thanks in advance y'all!!

I'm using a Monoprice Maker Select Plus printer with a Flexion HT extruder...printing silk rainbow PLA at 200 with the bed at 60.
IMG_0328.JPG
IMG_0330.JPG
IMG_0331.JPG

Return to “Troubleshooting and Bug Reports”