Page 1 of 1

Just Started Getting This Error - Any Ideas?

Posted: Fri Aug 02, 2019 7:15 pm
by wirlybird
Just Started Getting This Error - Any Ideas?

It is while exporting the file to print.

Been running parts most of the day. Same printer same settings etc. Just slicing the next part and sending to print via SD card.
1.png

Re: Just Started Getting This Error - Any Ideas?

Posted: Fri Aug 02, 2019 7:42 pm
by dkightley
A guess......your SD card is full....or at least the post processing cannot write to file...

Re: Just Started Getting This Error - Any Ideas?

Posted: Fri Aug 02, 2019 7:52 pm
by wirlybird
SD card is empty.
It has written this file several times and now has started this error.
I just keep moving the part on the bed for each copy and send a new gcode. Delete the last one first.
Moving it lets the PEI sheet settle a bit at the previous print location.