mondo50m
Posts: 11
Joined: Thu Mar 12, 2015 9:18 am

Need some quick help

Sat Aug 10, 2019 7:31 pm

I have been using Simplify 3D for over 5 years with no problems. I am using a MendelMax 1.5 printer. Just recently, it will no longer print the full width of the print bed. Y and Z axis are fine, but the X axis is not. It stops about 25 mm short of going all of the way across the bed. I have reset the printer many times and even tried to change the width of the print bed many times. Nothing seems to help. I have made changes to the width in both the Gcode and the options sections of the program. I am at my wits end trying to figure this out.....any help will be greatly appreciated.

Milton Maxson

mondo50m
Posts: 11
Joined: Thu Mar 12, 2015 9:18 am

Re: Need some quick help

Sat Aug 10, 2019 10:08 pm

Well, I figured it out guys. Somehow, the max for the X axis got changed in the arduino files. Just went in and changed it back....good to go.

Return to “Troubleshooting and Bug Reports”