Vertical size problem
Posted: Wed Aug 14, 2019 1:58 am
Hello. I ran into strange problem: Simplify seems to skip top layer, while printing.
When I try to print a model with a height of 30 mm by design, I get real part that’s 28.8 mm tall.
Primary layer height is 0.2 mm.
The model is quite simple, there are no support structures, rafts, etc.
In fact it's as simple as rectangular parallelepiped.
Please advise, what should I do to get printed parts to the correct height
When I try to print a model with a height of 30 mm by design, I get real part that’s 28.8 mm tall.
Primary layer height is 0.2 mm.
The model is quite simple, there are no support structures, rafts, etc.
In fact it's as simple as rectangular parallelepiped.
Please advise, what should I do to get printed parts to the correct height