Page 1 of 1

Can not print a hole in cylinder

Posted: Tue Aug 20, 2019 4:13 pm
by NihilUnum
Hi

I Can't print a hole in cylinder. And I really don't understand why.
Take a look on this pictures please.
Model01.JPG
And this what i got if I am trying to print
Model02.JPG
What I am doing wrong?
I have Ender 3 with Simplify3d v. 4.1.2. Any suggestions?

best
Adrian

Re: Can not print a hole in cylinder

Posted: Wed Aug 21, 2019 8:41 am
by wirlybird
Take a look at the bottom right on the advanced tab and remove the check mark if there for the merge all outlines into a solid model.
It says something like that.

Re: Can not print a hole in cylinder

Posted: Wed Aug 21, 2019 12:59 pm
by NihilUnum
My Saver!
This was it.
Thanks a lot!