cadkins
Posts: 1
Joined: Wed Sep 04, 2019 10:42 am

S3D not recogizing ID and OD of part

Wed Sep 04, 2019 10:59 am

I am trying to print a cylinder with hemispherical dome. after slicing the ID of cylinder is filled as well as blind hole on top of dome.

how to fix this?
Attachments
sk1978-11_fixed.stl
(1.08 MiB) Downloaded 4 times

wirlybird
Posts: 1215
Joined: Sun Jul 17, 2016 1:32 pm

Re: S3D not recogizing ID and OD of part

Wed Sep 04, 2019 11:30 am

Look on the advanced tab at the bottom right and uncheck "merge all outlines …" See if it helps.

Return to “Troubleshooting and Bug Reports”