Xerxes3rd
Posts: 4
Joined: Mon Apr 13, 2015 10:02 pm

FlashForge Dreamer USB Printing Filenames

Sat Oct 05, 2019 1:33 am

I recently upgraded from Simplify3D version 3.x to 4.x. Prior to 4.x, when I would do a print over USB, S3D would write the gcode file to a file called "temp" in the Dreamer's internal memory. In version 4.x, S3D now writes each print to a filename that starts with "Print_" and then contains a date & time stamp. Is there any way to revert this to the old behavior? I can never remember which file is which with the new way, and eventually my internal memory will just fill up. Thanks!

Return to “Troubleshooting and Bug Reports”