20181105ok
Posts: 9
Joined: Mon Nov 05, 2018 9:15 am

small solid zone on a sparse infill

Tue Oct 08, 2019 1:35 am

As shown in the picture, sometimes a small solid zone (Top Solid Layer) need to be put on a sparse infill (10%). Sometimes even if the Top Solid Layers is set to 5, the resulting quality is not as good. My current practice is to print a dense infill layer immediately below the small solid zone, but it turnes out to be very uneconomical when the infill area is large and the solid zone is very small.

I wonder how you handle this common siutation. Thanks for your sharing in advance!
Attachments
ScreenClip [1].png

Return to “Troubleshooting and Bug Reports”