Page 1 of 1

Printer goes to left in the middle of the print

Posted: Wed Nov 06, 2019 1:21 pm
by mroschk
Hello,

i have a strange problem.
When i print some models, which are around 2-3cm high, the printer starts very nice.
But then , anywhen in the middle of the print, the printer stops, goes to the left, comes back to the model and
continue working.
Sometimes the print is usable, but sometimes the print fails then.

Can anyone help to find out, what can be the reason for that ?
I never had this before.

Matthias