Just tried to use S3D but when i click to open it it briefly starts and then closes.
Things ive done
Uninstalled and reinstalled.
Run as Administrator.
Tried opening a gcode of a previous sliced stl
All the same opens then closes
At the moment using Puser Slicer but want to get back to S3D
Cheers
Re: Application starts but then closes
Try this....
Look in folder c:\users\YOURUSERNAME\AppData\Local\Simplify3D\S3D-Software for the file savedState.factory….and delete it.
If this file was corrupt, then you'll then be able to run S3D. It may be that you've previously used filenames with extended character set characters....which you should avoid.
Look in folder c:\users\YOURUSERNAME\AppData\Local\Simplify3D\S3D-Software for the file savedState.factory….and delete it.
If this file was corrupt, then you'll then be able to run S3D. It may be that you've previously used filenames with extended character set characters....which you should avoid.
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Re: Application starts but then closes
Cheers
Works nowdkightley wrote: Try this....
Look in folder c:\users\YOURUSERNAME\AppData\Local\Simplify3D\S3D-Software for the file savedState.factory….and delete it.
If this file was corrupt, then you'll then be able to run S3D. It may be that you've previously used filenames with extended character set characters....which you should avoid.
