Hi

I'm experimenting with thin wall parts on my Sidewinder X1. Normally I would prefer using Simplify3D over Cura oder Slic3r for those parts. Now I'm facing with a strange stop and go in printing speed on my Artillery Sidewinder X1. Also the the prints are very bad. Very interersting is the fact that the first layer doesn't suffer from this issue, but from the second layer starts the pain.

The g-code from the first layer looks like this:

...

G1 X151.645 Y68.512 E0.0005 F900

G1 X156.176 Y68.602 E0.2266

G1 X156.193 Y68.603 E0.2274

G1 X160.167 Y68.833 E0.4260

G1 X160.183 Y68.835 E0.4268

G1 X162.558 Y69.057 E0.5458

G1 X162.572 Y69.058 E0.5465

G1 X164.813 Y69.338 E0.6592

....

From the second layer looks like this:

....

; feature external single extrusion

; tool H0.200 W0.446

G1 X153.196 Y69.648 F12000

G1 E0.0200 F1800

G92 E0.0000

G1 X153.274 Y69.649 E0.0029 F900

; tool H0.200 W0.424

G1 X154.869 Y69.670 E0.0592

; tool H0.200 W0.398

G1 X155.268 Y69.675 E0.0724

; tool H0.200 W0.392

G1 X155.348 Y69.677 E0.0750

; tool H0.200 W0.397

G1 X156.065 Y69.700 E0.0987

; tool H0.200 W0.402

G1 X156.143 Y69.703 E0.1013

; tool H0.200 W0.403

G1 X156.218 Y69.706 E0.1038

; tool H0.200 W0.401

G1 X157.064 Y69.743 E0.1321

; tool H0.200 W0.399

G1 X157.141 Y69.746 E0.1346

; tool H0.200 W0.400

G1 X157.449 Y69.762 E0.1449

; tool H0.200 W0.402

G1 X157.524 Y69.765 E0.1474

; tool H0.200 W0.402

Could it be possible that the the adition "; tool H0.200 W0.402" cause this problem? Is it possible to remove it from the post processing?

Here you can see how the stop and go behaviour on my Sidewinder X1:

https://youtu.be/hLQJdPx6YXo

Many thanks in advance

Michael