Page 1 of 1

Ender 5 with TH3D firmware and Silent Board

Posted: Sun Dec 01, 2019 10:23 am
by demetri90
Just an FYI, I have not tested this yet. For those upgrading to the "Silent" board for your Ender 5 and using TH3D firmware, you'll notice the axis are flipped. Not exactly sure the cause but I think Simplify3d should have a profile for the Ender 5 with Silent Board. I think the Homing Direction under G-Code needs to be set to Max instead of Min, again not sure yet as I had to put my old board back in to get some prints finished.

https://forum.th3dstudio.com/d/30-ender ... ackwards/3