R2D2Rodriguez
Posts: 9
Joined: Sun Mar 10, 2019 8:20 pm

Opposite Side of model

On my simplify 3d screen my 3d model is correct and as it finished during the night , I notice the eye / hole was on the opposite side of model.
Any suggestions on how this could have happen? Several hours and filament down the drain, good practice.
User avatar
dkightley
Posts: 2405
Joined: Tue Mar 10, 2015 4:09 pm

Re: Opposite Side of model

You may need to either tick or untick one of the Flip bed axis flags in the Machine tab of General Options.
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net

Return to “Troubleshooting and Bug Reports”