Hi All,
I have been having issues with my Tevo Little Monster. The printer stops about half way through the print. Just completely dies, but the temps all read good even though the hot end is cold. Turns out that the issue was the TL Smoothers that I added. I removed them and the next print was successful. So, this was all my bad and since then, I have replaced the smoothers with new ones and all is good. BUT!!! during this down time I have wrongfully been accusing S3D for this issue, because my problem started after a new release of S3D and that was just coincidental. I wrote this to let people know you can keep your faith in S3D.
Thx