namessuck
Posts: 1
Joined: Mon Dec 23, 2019 1:17 am

New user question about how file is printing

Mon Dec 23, 2019 1:30 am

Just purchased the software and was going to print a small 4 mm thick plaque that I imported. I have printed one in Cura before and it import standing up when I lay it down on the bed in the cura program it prints from the bottom up when I lay it down on the bed and this program it doesn't want to print bottom up it prints in a strange pattern to where it doesn't turn out. Not sure why it wants to print that way because there is no way it could turn out that way. Is there a setting somewhere?

Return to “Troubleshooting and Bug Reports”