Page 1 of 1

Centralise my carriage to Bed on E3D Big box printer

Posted: Thu Jan 09, 2020 3:02 pm
by Jaredmanley
Hi,
I have an E3D Big Box dual printer and I'm having issues with getting the carriage to start printing in the centre of the bed. My computer just got repaired and the program got deleted, so I've got the original scripts which I copied across after downloading SIMPLIFY 3D again. They don't place the carriage in the same positions when purging (collide with the housing) and centralising to the bed before printing. Can anyone tell me what and where to write the correct Gcode to resolve this please?

Re: Centralise my carriage to Bed on E3D Big box printer

Posted: Fri Jan 10, 2020 10:42 am
by S3D-Alex
Could you please post a Factory File so we can look into this further?

Re: Centralise my carriage to Bed on E3D Big box printer

Posted: Sun Jan 19, 2020 3:58 pm
by Jaredmanley
apologies for my late responce
SI2 TEST.factory
(9.48 KiB) Downloaded 23 times

Re: Centralise my carriage to Bed on E3D Big box printer

Posted: Mon Jan 20, 2020 8:57 am
by Jaredmanley
apologies for the late reply. here is the attached fff
E3D BigBox Dual.fff
(24.32 KiB) Downloaded 28 times