Page 1 of 1

Stringing

Posted: Thu Jan 09, 2020 3:31 pm
by john_d12
Hi
Please could someone help l made a print on my Cr10s I used pla temp 215 and bed temp was set a 70, the print turned out good but I got strings and blobs of filament which weren’t really attached to the print? Please could someone help me.
Thanks
CD076043-2AC3-4886-9D23-5D695D1FB55A.jpeg

Re: Stringing

Posted: Fri Jan 10, 2020 10:44 am
by S3D-Alex
I would first suggest printing a little cooler as 215 is most likely a little hot for most basic PLA filaments. Can you please post a Factory File so we can look into this a bit more?

Re: Stringing

Posted: Fri Jan 10, 2020 11:51 am
by TheBum
That was my first though as well. PLA typically prints best around 200C, sometimes as far down as 190C.

Re: Stringing

Posted: Fri Jan 10, 2020 5:21 pm
by dkightley
Also, have a read of this: You may pick up some useful info.... https://www.simplify3d.com/support/prin ... or-oozing/