davorin
Posts: 33
Joined: Wed Dec 27, 2017 1:25 pm

License limit reached on each start on Linux

Sat Jan 11, 2020 10:08 am

Good afternoon

Each time I start Simplify3D 4.1.2 on Debian Buster I get notified that I have reached the maximum number of licenses....and in the account page I have to deactivate it....until I restart Simplify3D again...

And every time I see my machine listed as "Linux"...

On macOS 10.13.6 I never had this issue...


thanks in advance
richard

S3D-Alex
Posts: 350
Joined: Thu Aug 30, 2018 1:23 pm

Re: License limit reached on each start on Linux

Mon Jan 13, 2020 9:30 am

Could you please contact us at Support@Simplify3D.com so we can look into this further?

themonet
Posts: 2
Joined: Fri Jan 10, 2020 12:07 am

Re: License limit reached on each start on Linux

Sat Jan 25, 2020 5:56 pm

I am having this same issue as well. Was there any progress on this error? TOTAL Linux newbie here, so it could very well be something I'm doing wrong.

S3D-Alex
Posts: 350
Joined: Thu Aug 30, 2018 1:23 pm

Re: License limit reached on each start on Linux

Tue Jan 28, 2020 10:43 am

Could you please contact us at Support@Simplify3D.com so we can look into this further?

arhi
Posts: 435
Joined: Thu Oct 06, 2016 5:13 pm

Re: License limit reached on each start on Linux

Tue Jan 28, 2020 11:01 am

S3D-Alex wrote:
Tue Jan 28, 2020 10:43 am
Could you please contact us at Support@Simplify3D.com so we can look into this further?
Looks like this thing with linux is rather "common" maybe a proper FAQ about handling this issue on Linux could benefit more ppl having Linux issues
gcodestat integrates with Simplify3D and allow you to
Calculate print time accurately (acceleration, max speed, junction deviation all taken into consideration)
Embed M117 codes into G-Code
Upload your G-Code directly to Octoprint
open source and unlicence

Return to “Troubleshooting and Bug Reports”