will4836
Posts: 1
Joined: Sun Jan 05, 2020 8:08 pm

Infill not Slicing/printing

Tue Jan 21, 2020 7:09 pm

Hi all,

I have just begun using S3D and am having an issue with my print. I am trying to print a part for a model airplane which has thin 0.4mm walls. However, there are some areas that are solid which I would like to have infilled. For some reason these areas will not slice with any infill though - they are just hollow.

Any suggestions? I have attached the STL file below (for some reason I can't attach the IPT file - any thoughts?)

Any help is very appreciated! Thanks - Jim
Attachments
print_4.PNG
print_3.PNG
T1.stl
(28.7 KiB) Downloaded 5 times

Return to “Troubleshooting and Bug Reports”