mafracao
Posts: 2
Joined: Wed Jan 22, 2020 10:03 am

Ender 3 Pro with "silent board" bug with S3D gcodes

Wed Jan 22, 2020 11:36 am

Hello;
I've already reported this issue with the Simplify3D support team, since I don't know if they are aware of it.

After upgrading my Creality Ender 3 Pro with the new 1.1.5 "Silent board", every print fail due to stoppage of the extruder step-motor. It simply stops around 30min into the print, for no reason. There are no mechanical issues in my printer, and the very same STL file, when sliced in CURA, prints normally.

This issue was reported by a few users from what I researched online. I've even followed a tutorial to update the board to Marlin 1.1.xbugfix and change some driver settings, but no improvements were shown. The S3D sliced prints keeps failing.

Is there someone that experienced this issue? Is there a fix for it?

Return to “Troubleshooting and Bug Reports”