Dubcuda
Posts: 2
Joined: Wed Jan 22, 2020 3:27 pm

Flash Forge Creator 3 defult settings

Wed Jan 22, 2020 3:47 pm

Just a FYI: My company just bought a Flash Forge Creator 3. I prefer to use Simplify 3d because i have been using it for years and didn't want to learn a new slicer program. I had issues with the 1st layer not bonding to the build plate until i changed the default bed heat settings from 45° to 60°. I was using PLA that came with the printer, maybe that's the issue it did come from China. I think the default setting should be tweaked just a bit for this printer. Also had a bit of a ooze issue i am still trying to figure out. Thanks and i enjoy using your software! :D

Return to “Troubleshooting and Bug Reports”