Posts: 1
Joined: Fri Jan 24, 2020 1:30 pm

Speed or Heat??

Fri Jan 24, 2020 1:54 pm

Hi Everyone,
On the newer side of 3D printing and trying to dial in the best settings for this material.
I looked on the trouble shooting guide, but I can't figure out exactly what the problem is and it seems like it could be more than one.
I figured I would see if anyone with more experience could tell me what to focus on before arbitrarily trying fixes at random.

I have already tried to re-level my print bed to see if that was part of the solution.

The infill seems to be wavy, which made me think it was a vibration and possibly a speed issue. It also seems to get worse the further into the print I get
But the infill also seems to sag, so maybe it's temperature?

I am using a Raise N1
The material is ABS from 3D Soutech
Obviously Using Simplify 3D software

I am attaching two pictures of my recent attempt

Any help would be super awesome!!

Posts: 78
Joined: Wed Feb 07, 2018 4:26 pm

Re: Speed or Heat??

Sat Jan 25, 2020 9:10 am

Why aren't you using ideamaker?

Return to “Troubleshooting and Bug Reports”