I just purchased the new Flashforge Creator Max but I'm having problems getting S3D to work with it. I selected the Creator Pro during the configuration since I understood that the Max is the evolution of that printer. But when I create the print file, then run it in the printer, the printer makes grinding noises and starts making the print movements well above the plate and no extrusion is taking place. When comparing the file extensions on the print files, one created with the slicer that came with the printer and the file created with S3D, I noticed the Flashforge print file extension ended with .gx, while the S3D file extension is the .x3g. At any rate, what am I missing? What is the correct settings? Firmware type? I see where at least one other person is using S3D with the Creator Max with some success. Thanks!