alfista2600
Posts: 1
Joined: Sun Feb 02, 2020 2:45 pm

Basic Fan Control - Qidi Tech-1

Sun Feb 02, 2020 3:03 pm

Hi - I'm somewhat new to this...

My qidi tech-1 seems to always use the right fan, whether printing from the left or right hot-end.

I can't figure out where to change it.

I'm using OctoPrint (OctoPi) to send data to the printer.

Any tips?

wirlybird
Posts: 1235
Joined: Sun Jul 17, 2016 1:32 pm

Re: Basic Fan Control - Qidi Tech-1

Sat Feb 08, 2020 10:53 am

Try without Octo.
Also the two fans on the front of the extruders are controlled by the main board/firmware. You have no control over them. They are to cool the extruder.
The part cooling fan is on the left side of the extruder setup.

Return to “Troubleshooting and Bug Reports”