I have to print a lot of the shapes on the photos.
I was modeling the support manually to save material and get the best results.
Works well so far (See pictures attached - they are too large to place inline)
However printing with no support basically works and saves over 50% of material and printing time.
Just the results are not satisfying.
The edges of single unsupported areas warp up due to the heat exposed.
Is there any tricks to avoid such behavior, like only printing 1 perimeter a time and coming back for the others later,
so there is enough time for cooling down?
Or something else I haven't thought of?
(Fan runs at 100%)