freakaccident
Posts: 10
Joined: Fri Jan 31, 2020 11:18 pm

Print issue...walls of print too thin.

Fri Feb 07, 2020 8:32 pm

So I printed a cube and the walls are so thin that there are holes in them. I have attached a pic. What could be causing this? Not enough material being extruded? Should I change the multiplier?
Attachments
IMG_20200207_202754.jpg

S3D-Alex
Posts: 375
Joined: Thu Aug 30, 2018 1:23 pm

Re: Print issue...walls of print too thin.

Tue Feb 11, 2020 8:49 am

Could you please post a Factory File so we can look into this a bit further? Are you currently printing with only one perimeter?

Return to “Troubleshooting and Bug Reports”