Hi All,
I've recently come over to Simplify3d from Cura and have spent the last couple days getting started. I order to get to know simplify3d, I've tasked myself with printing something that Cura has been able to slice for me very well.
However, I'm struggling to get to grips with the 'outline/perimeter shells' setting. So far, I've set it to a value of 3 but as per the preview, I can only see two out-most walls being printed (see attached image)
Any ideas? What I'm after is for the out walls to have 3 shells not the current 2 you can see in the preview. I'd also like the infill area in the 'top layer' to be solid lines and not infill, something I think would be achieved if the settings of 3 perimeter shells was being respected. I suspect there's a setting somewhere that is overriding my outline setting but for the life of me I can't figure out what it is.
Thanks in advance!