Posts: 1
Joined: Sun Mar 22, 2020 7:33 am

Simplify Delta problem

Sun Mar 22, 2020 7:38 am

I've got Anycubic delta with SKR 1.3 board, when trying to print anything using Simplify via USB, program sends nozzle out of printing border as soon as printing starts. No such problem on Cura 4.5. I've clean out starting G-code, still nothing.

Posts: 343
Joined: Thu Aug 30, 2018 1:23 pm

Re: Simplify Delta problem

Mon Mar 23, 2020 1:30 pm

Could you post a Factory File that exhibits this behavior? You can save this off by going to Save > Factory File As...

Return to “Troubleshooting and Bug Reports”