Hello all, I have a taz 6 dual extruder v3. This moring i adjusted my z probe offset and saved the offset change using M851 and M500. After I did that I went to print a Mr Meeseeks and notice this.
https://www.youtube.com/watch?v=YVP6nQpiupw
No idea how changing the z probe screwed up the wiper and Probe locations. Ive reset this print 4 times now all the same outcome.
Im printing via USB to Octoprint, Also Ive printed 3 other meeseeks before this with no problem.
Any help is appreciated thanks All,
Phillip
-
pcamera123
- Posts: 1
- Joined: Sun Mar 29, 2020 3:54 pm
