Posts: 2
Joined: Tue Oct 23, 2018 7:50 pm

What am I doing wrong?

Tue Apr 07, 2020 12:24 am

I'm not sure what I'm doing wrong =(

I don't know if it's a setting in the software I have messed up, or if it's something out of whack on my printer. Any help would be greatly appreciated :)

Thank you!!!

Posts: 4
Joined: Tue Apr 07, 2020 6:49 pm

Re: What am I doing wrong?

Tue Apr 07, 2020 7:47 pm

Hey, what material are you using to print and is that stringing I see?

Posts: 133
Joined: Fri May 18, 2018 11:13 pm

Re: What am I doing wrong?

Fri Apr 10, 2020 1:18 pm

Looks like a serious lack of adhesion to me. Without knowing the material you're using or the temperature you're printing at, I couldn't even take a guess as to the cause. Please save a factory file and upload it here in addition to telling us what the material is.

Posts: 1
Joined: Sat Apr 11, 2020 8:31 am

Re: What am I doing wrong?

Sat Apr 18, 2020 5:37 am

I had a similar issue. I increased the extruder temp, slowed down the default print speed, and increased the extrusion multiplier. About 5 % at a time. I’m very new to this, I’m not sure which adjustment fixed the problem. Check out the print quality under the support section of this website, its helped me a lot.

Return to “Troubleshooting and Bug Reports”