Page 1 of 1

Solid infill on first layer not working

Posted: Mon May 18, 2020 4:18 pm
by Telson
Hi hopefully someone can help with some advice.
I am having issues with the solid infil on the first layer.
As you can see in the image The Skirt prints fine, The prime Pillar prints fine, The Ooze shield prints fine, and so do the perimeters of the model.
The only thing not printing is the solid infill. The extruder just clicks, the hot end is the correct distance from the bed, the temperature is 205 bed 55 , You can clearly see my bed is level based on the parts that do print.
I am guessing there is setting somewhere within S3D that I need to change, Anyone have any ideas?

Image