Changing the speed while printing works fine from the printer´s own hardware display. I'm using Sailfish 7.7 firmware.
-
joohansson
- Posts: 3
- Joined: Fri Oct 03, 2014 3:56 am
Dynamic speed control
I'm trying tune the speed of Wanhao duplicator 4x by using machine control panel inside Simplify3D. Nothing happens, it still printing with same speed. How is this intended to be used? I'm trying to change speed while printing.
Changing the speed while printing works fine from the printer´s own hardware display. I'm using Sailfish 7.7 firmware.
Changing the speed while printing works fine from the printer´s own hardware display. I'm using Sailfish 7.7 firmware.
Re: Dynamic speed control
This isn't supported by sailfish over USB. You have to use the LCD if you want to adjust speeds in real-time.
-
joohansson
- Posts: 3
- Joined: Fri Oct 03, 2014 3:56 am
Re: Dynamic speed control
Ok thanks!
Re: Dynamic speed control
Further if you change tabs to the communication tab you'll and turn off verbose so it isn't scrolling by fast you'll notice the error where it says it isn't supported.
