Bo1o1
Posts: 5
Joined: Sat Sep 28, 2019 11:53 am

How to Start Tool 1 part cooling fan

Wed Jun 10, 2020 10:25 pm

I have an IDEX system.. and I am using Tool 1, but Tool 0 is the main tool with a BL Touch on it.. so I can't mess with it to much.. but I did add Volcano to Tool 1 and set the Z - offset to make it work.. BUT, I am using PETG today.. not ABS which I have been.. and I notice no fan starts on the Tool 1, Tool 0 thats not even warmed up is running like a champ.. I can turn it on thru the Panel interface under TUNE, but I have to let it do first layers then remember to start the fan.. there must be a way..

Return to “Troubleshooting and Bug Reports”