I do not know why no one has reported this but it has me about to take a hammer to the printer!!!
The start script for the CR-10s pro is BROKEN!!!!
It does the G28, then the G29 and ends at the back right corner.
Then moves the head all the way to the left front corner.
Then moves to the center of the build plate and does the wipe towards the front of the build plate so ...
1. I have the wipe in the middle of my print
2. the thing is moving from back to front so you cannot scrape the thing off or see the wipe at all as it is BEHIND the print hea]d!
I have the latest version of the creality firmware installed 1.70.1.
Here is the script:
G28 ; home all axes
G29 ; auto-bed level
G1 Z5 F3000 ; lift
G1 X5 Y10 F1500 ; move to prime <---- it does not go here! It goes to the front left corner then moves to the middle of the bed
G1 Z0.2 F3000 ; get ready to prime
G92 E0 ; reset extrusion distance
G1 Y80 E10 F600 ; prime nozzle <---- then does this!!!!! Moving from the middle towards the front of the bed!!!!
G1 Y100 F5000 ; quick wipe
If I take the G29 out then it works correctly of if I put another g28 after the g29 but then I wipe all my bed leveling db!!!!
WTF is wrong?>>??"???
It is makeing me INSANE!!!!