Posts: 86
Joined: Fri Jun 05, 2015 4:18 am

Re: No supports generating

Mon Jun 29, 2020 11:48 am

sinabu wrote:
Sun Jun 28, 2020 1:39 pm
I think he came out pretty good. Just need to debur the support spots :) I used WYZ Clear PLA. He is going to sit on an RGB Header inside a PC Case so hopefully the colors will shine through some :)
From what I can see this does look good, yes. Maybe there's still some settings to optimize regarding supports to ease cleanup - but on a slope like that it won't probably make that much of a difference.

Colors should shine through. Clear PLA is not bad at diffusing light somewhat but it often depends on various parameters. Print alignment/direction (facing leds along X/Y or Z), infill patterns and such. If you happen to have some WS2812 leds laying aroung, you're welcome to have a look at my thingiverse profile for possible weekend projects... ;-D

Return to “Troubleshooting and Bug Reports”