AraStar
Posts: 1
Joined: Sat Jun 27, 2020 11:22 am

FlashForge Finder heating issue

Sat Jun 27, 2020 11:28 am

Hey there peeps ~

I've been through every video I can find to learn about the in's and out's of this (my first) machine. Here's the prob:

When I start the machine everything works fine. Pre-heat is quick and holds well. As soon as I hit 'build', the temp drops a few degrees and causes the machine to be in 'warming up' mode and eventually not print at all.. If I do get a print to start it usually takes less than 5 minutes for the temp to start rapidly dropping. Go back to pre -heat and it gets right back to 220.

I've tried files from Thingi as well as test prints that came with the machine. It is second hand with a new thermistor. I've checked the connections and made sure all is tight. At a loss and a bit sad....as is my daughter who's waiting for her first baby yoda. ;)

Thanks for any help!

S3D-Alex
Posts: 412
Joined: Thu Aug 30, 2018 1:23 pm

Re: FlashForge Finder heating issue

Wed Jul 01, 2020 9:45 am

Could you maybe post a Factory File so we can check and make sure everything looks good from the software side? You can do this by going to File > Save Factory File As...

Return to “Troubleshooting and Bug Reports”