dandixon
Posts: 1
Joined: Tue Jul 07, 2020 10:10 pm

Help with Raise3d pro2 plus

Wed Jul 08, 2020 9:02 pm

I've run a few test prints, and both have failed. The first few layers work great, but as soon as it starts to print the inner fill, it doesn't seem to lay the material down. Also, the print times coming out of Simplify3D are almost half the time coming from Ideamaker. It appears to be a speed issue, but the setting seems to be close to the setting in IdeaMaker. Does anyone have a default setting for the Pro 2 printer?

I'm new to printing but, seem to be getting good results with IdeaMaker but was told Simplify3D is a bit better. I love to see if I can get it to work.

Thanks

Been testing with Ultrafuse PAHT CF15.

Return to “Troubleshooting and Bug Reports”