Page 1 of 1

Stopping/starting mid-print

Posted: Mon Jul 20, 2020 9:08 am
by Statue
Hello All:

I have a TronXY XY-2 Pro - a friend recommended Simplify3D and I wanted to give it a try. Everything works fine until I try to print - it prints for about 9 seconds, then stops for about 3 seconds, then this repeats throughout the print, ruining it. You hear the fan also stop whenever the print stops. If I turn on verbose logging, there's nothing unusual there - it also stops and starts. How do I fix this?

Lance

Re: Stopping/starting mid-print

Posted: Sat Aug 01, 2020 12:57 pm
by jane477
Hello All:

I have a TronXY XY-2 Pro - a friend recommended Simplify3D and I wanted to give it a try. Everything works fine until I try to print - it prints for about 9 seconds, then stops for about 3 seconds, then this repeats throughout the print, ruining it how to write a resignation letter. You hear the fan also stop whenever the print stops. If I turn on verbose logging, there's nothing unusual there - it also stops and starts. How do I fix this?

Lance
Hello
I'm also relatively new to the subject but seems like you are running out of memory and that’s why process restarts