Posts: 6
Joined: Sun Jul 26, 2020 1:50 pm

BLTOUCH v3 and Z Offset changing

Sun Jul 26, 2020 1:59 pm

I have just started using Simplify 3D and have noticed that I’m having to re-check and change the Z Offset before each print.
I never had this problem using Cura and never had to change the Z Offset before until I started using Simplify 3D.

Is there a setting I’m missing?

In the starting g-code I am using the same start up code as in Cura ( inc. g28 and g29)

Return to “Troubleshooting and Bug Reports”