wirlybird
Posts: 1240
Joined: Sun Jul 17, 2016 1:32 pm

Support Upper Separation Issue

Fri Jul 31, 2020 4:06 pm

So when printing at a 0.2mm layer height and using 1 layer for upper separation for supports it works fine.
If I drop to a 0.16mm layer height and still use a 1 layer separation height I get a lot of bonding between supports and the part on top of supports.

If I go to 2 layer separation then I get some messy layers over supports.

Anyone come up with a way to do better with this? I so wish they would do support spacing by layer OR actual thickness.

Return to “Troubleshooting and Bug Reports”