Page 1 of 1

Cafrtbot3

Posted: Mon Sep 14, 2020 2:59 pm
by Boskizx2
Hello all.
Today I was asked to work off a craftbot 3 at work. I plugged in my laptop got the FFF from the drop down in S3D. I saw that it changed the build platform from my sidewinder x1. Sweet everything looks smooth, however when i sliced and asked to print it heats up fine and homes, moves to start location then stops. i wait for a while (about 15min) but still no movement. I saved to a flash drive and put the in the printer and it works fine from s3d. I Tried all my USB ports on my laptop with the same result. so in short wired no worky usb stick worky. any ideas???