Posts: 1
Joined: Sat Oct 03, 2020 4:56 am

First time post with a question

Sat Oct 03, 2020 5:19 am

Hello I am new to this forum. I use a Dremel 3D20 that I bought second hand and I am amazed at the results that I am getting, some what above my expectations.

About two months ago I switched from the Cura/Dremel software to Simplify 3D, I think this jump was worth the investment.

I have a question about surface finish that definitely relates to the software and not the hardware.

In the attached image. How would I remove the light blue lines that occur about every 10 layers as the software works up through the part? I want to try and get a smooth surface, the finished part looks identical to the screen shot with a slight witness of the blue lines in the part.


Thanks in advance.


Return to “Troubleshooting and Bug Reports”