jackt99
Posts: 1
Joined: Fri Oct 02, 2020 7:42 pm

Printed this lithophane twice, but problem still persists.

Sun Oct 04, 2020 9:27 pm

I have been working with my Ultimaker S5 to get the perfect settings. I decided to print a globe lithophone, which printed perfectly until about 60% through the print. The first try (on the left) has extensive layer-stuttering. For the second, I decided to lower the layer height (0.45 --> 0.3), raise the print temp (205 --> 215) and increase the retraction distance (6.5mm --> 8.5mm). It did help drastically, but the layer stuttering is still present and in the exact same spot. I am using a 0.4 nozzle and printing with freshly bought PLA. Any suggestions on how to tweak this? Thank you very much!
Attachments
IMG-2578.jpg

S3D-Jake
Posts: 872
Joined: Wed Jun 20, 2018 12:45 pm

Re: Printed this lithophane twice, but problem still persists.

Mon Oct 05, 2020 3:16 pm

Do other prints (non-globe lithophane) also show this issue when they get to that height in your build area?
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “Troubleshooting and Bug Reports”