Hello, I'm a new user of Simplify3D and quite happy with the slicer, its options and the print quality.
I just can't find a way to improve the little blobs on the seam of the perimeters. I know this has been asked many times here but I haven't found a solution and everything I try makes the blobs "different" but doesn't improve the quality. I've looked at the print and the blobs are starting when the printer is ending the infill and going over to the perimeter. It looks like there is a little stop at the point it goes over to the perimeters and then filament is oozing out of the nozzle. I've tried playing around with coasting but even when I increase it up to 5mm (started with 0.2, 0.4...) to see an effect the blob just appears earlier.
I would appreciate any help.
(Printer is a Ultimaker 2+ with Bondtech Extruder and a Duet Wifi board).