framrec
Posts: 1
Joined: Fri Dec 18, 2020 6:30 am

Overhangs with zero filling

Fri Dec 18, 2020 6:39 am

Friends, good afternoon everyone, help out !!!
I have to print a part that has some perimeter walls at an angle. Padding must be "0" (that is, no padding). Vertical walls are printed perfectly (indicated by blue arrows), but on inclined walls Simplify 3d itself adds filling in the form of plastic overhangs (indicated by red arrows). This is problem!!! They are not needed !!! Please tell me how to remove them completely !!! )))
I would be grateful for constructive and open answers, thanks !!!
Attachments
Снимок.JPG

Return to “Troubleshooting and Bug Reports”