Talsit
Posts: 1
Joined: Sun Jan 03, 2021 12:11 pm

Lulzbot Mini 1.4 inconsistent print start

Sun Jan 03, 2021 12:18 pm

This might have been answered and I'm just not figuring out how to search for it.

I have a Lulzbot Mini 1.4. It took a lot of toying to finally have an acceptable print, I kept having issues with the fist layer and the gap between the extruder and the bed but I got it to print.

After the print I took the printed item off and hit print on S3D and I was back to the the same issues as before, I toyed with it again actually undoing the steps I did before and it finally printed again.

I loaded up a new file to print (didn't touch the printer profile) and... same issue.

I'm using stock everything and standard Sun PLA+, once the gap is set, everything is fine but I feel like I should have to burn through a lot of filament toying with settings that didn't change in order to get this to print.

Return to “Troubleshooting and Bug Reports”