Angate
Posts: 1
Joined: Fri Jan 08, 2021 8:59 am

First real print 'finished' incomplete

Fri Jan 08, 2021 9:08 am

I just purchased and am moving over from Cura. I successfully printed an XYZ cube and stepped up to printing some game tiles. From what I can tell the slicing was successful and shows about 11.5 hours to complete. I sent the gcode over to octoprint and let it run. After over 12 hours the printer said it was done and it it only completed the first 50 or so layers. Less than half of the layers required. What should I look to for the issue? Did I do something obviously wrong here?
Attachments
Screenshot 2021-01-08 000638.png

Return to “Troubleshooting and Bug Reports”