Hello, just purchased this software and already need support.. not happy so far. either way will give this a shot. uploaded a file, switched gcode to standard clicked begin print over usb and it says printing but nothing is actually happening. this is the comm tab. printer is the Davinici Jr 1.0 W, i can enable extruder and jog a bit but not to very top and home seems to jam at bed
READ: ok T:22 /0 B:20 /0 @:0 B@:0
SENT: M105
READ: ok T:22 /0 B:20 /0 @:0 B@:0
SENT: G90
SENT: M82
SENT: M106 S0
SENT: M104 S190 T0
SENT: M109 S190 T0
READ: ok
SENT: M105
READ: ok
READ: ok T:22 /0 B:20 /0 @:0 B@:0