partyk1d24
Posts: 1
Joined: Wed Mar 17, 2021 11:56 pm

Coming from Cura, not able to get full brim. (PETG)

Thu Mar 18, 2021 12:18 am

Sorry in advance I come from CURA. I am trying to get a basic 8mm or so brim and since that isn't working very well there are gaps. I pushed it down till it was at the bed and couldn't find a sweet spot. Bed is Level...

Image

Checked the Z-offset but still get

Image

This causes the layers to pull away.

If I use Cura I don't see gaps in the layer I will post pics later confirming.

Is there some trick to brims?

User avatar
dkightley
Posts: 2333
Joined: Tue Mar 10, 2015 4:09 pm

Re: Coming from Cura, not able to get full brim. (PETG)

Fri Mar 19, 2021 12:35 pm

When you post your addn prints later, please sort out the above prints...They're not showing.

Try adding files directly as attachments, and don't use links to photo sites ...or to the hard drive on your own PC.
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net

Return to “Troubleshooting and Bug Reports”